Thank you for purchasing a Supporter pack! Your donation helps us make MAGLabs even better! Follow this guide in Makerspace to assemble your Badge Enhancement Module.

Guide

Break each pin connector into a 6-pin and a 5-pin piece.
Insert the pin connectors into each other
Rubber-band together the Badge enhancement module on top of the pins, ensuring to line up the pins with the badge.
Solder the corner pins on, then remove the rubber band. Then, solder the remaining pins.
Repeat with the back of the badge
Trim off the paper ends of the resistors.
Bend the resistors and slot them into the module, following the color codes printed on the module. Then solder it.
Slot the LCD screen into the module and solder it to the module.